This project is from 2 weeks ago, I thought I posted it but I guess not.
This is an oval box (1 seam) but I put a hydraulic pressed stamping on the lid. I did the stamping twice just to practice getting a good impression. Actually this is the second oval box too; the first was out of 24g copper which is just too soft and this one was made with 20g which is still a bit too thin, for copper but these are all about practice.
I spent a good amount of time working on the bezel for the lid and I am getting better at fitting it and soldering as I am not doing as much clean up. This box is about 1.25" tall and a 6" circumference resulting in about 1.25" wide on the short axis and 1.5" on the long axis.
Next up scribing corners, I am starting with a triangular box.
This is an oval box (1 seam) but I put a hydraulic pressed stamping on the lid. I did the stamping twice just to practice getting a good impression. Actually this is the second oval box too; the first was out of 24g copper which is just too soft and this one was made with 20g which is still a bit too thin, for copper but these are all about practice.
I spent a good amount of time working on the bezel for the lid and I am getting better at fitting it and soldering as I am not doing as much clean up. This box is about 1.25" tall and a 6" circumference resulting in about 1.25" wide on the short axis and 1.5" on the long axis.
Next up scribing corners, I am starting with a triangular box.
RSS Feed
